Remove the radio by using the removal clips. If you cannot find your clips anymore, use alternative removal clips.

Slide the radio out and disconnect the aerial, power and speaker connectors. Remove the radio from the car.

On the underside of the radio at the front fascia, there is a black strip. Lever the little black piece and slide in the direction indicated. Pull the black strip free from the unit.

On the top of the radio panel, there are two screws which need to be removed.

The top and bottom sections of the radio need to be levered apart at the back. This will break the warranty seal.

Remove each of the sections as shown.

The fascia unclips from the front of the unit.

This will reveal the PCB on the front of the radio.

You may choose to put the top and bottom sections back on the radio whilst you work on the LEDs.